How to install a French drain

Dig a sloped trench, lay perforated pipe in washed gravel, and carry water from a soggy spot to an approved outlet.

About 1 to 2 weekends Moderate

This guide covers a shallow yard drain that flows downhill by gravity, not a foundation drain. Check that the outlet is low enough before buying pipe or digging.

Start this project

Calculators for this job

Tools

  • Tape measure, stakes, and string line
  • Line level
  • Shovel or trencher
  • Rake and wheelbarrow
  • Hose

Materials

  • Water-permeable landscape fabric
  • Washed drain gravel
  • Perforated drain pipe and fittings
  • Solid outlet pipe and outlet fitting
  • Topsoil and sod or decorative rock

Steps

  1. Find the wet spot and an outlet

    After a rain, note where water collects and where it could flow. Look for a lower spot on your property, a suitable dry well, or a street curb where discharge is allowed. Never send water onto a neighbor's property.

  2. Check local rules and mark utilities

    Ask your city and HOA about drainage rules, approved outlets, and any permits. Call 811 and wait for utilities to be marked. Locate private irrigation lines separately before digging.

  3. Plan and mark the route

    Use stakes and string to mark the line from the wet spot to the outlet. Plan for at least 1 inch of fall every 8 to 10 feet, with a steady downhill slope and no low spots along the way.

  4. Dig the trench and check the slope

    Dig the trench about 12 inches wide and 18 to 24 inches deep where the route allows. Set a level string line and measure down to the trench bottom at several points. Adjust the bottom until it drops steadily toward the outlet.

  5. Line the trench and add gravel

    Line the bottom and sides with water-permeable landscape fabric. Leave enough fabric on both sides to fold over the top later. Spread a few inches of washed drain gravel on the bottom and check that it follows the planned slope.

  6. Lay the perforated pipe

    Set the pipe on the gravel with the holes facing down. Connect the sections and check that the pipe slopes steadily toward the outlet without dips. Use solid pipe to carry water from the trench to the discharge point.

  7. Cover the pipe and fold the fabric

    Add washed gravel around and over the pipe without shifting it. Fold the fabric over the gravel and overlap the edges so soil cannot wash into the trench.

  8. Finish the surface

    Cover the fabric with topsoil and sod, or finish with decorative rock. Match the surrounding grade and keep the outlet and any cleanout accessible.

  9. Finish the outlet and test the drain

    At the low end, fit a pop-up emitter or leave an open outlet where water can discharge safely. Run a hose into the high end of the pipe and check that water comes out at the outlet without backing up or pooling where it discharges.

Tips

  • Rent a trencher for long runs where the route is clear of utilities and irrigation.
  • Use clean, washed gravel with no fines, which can clog the drain.
  • Add an accessible cleanout at the high end so you can flush the pipe later.

Safety

  • Always call 811 before digging. Watch for private irrigation lines that may not be marked.
  • Lift with your legs and use a wheelbarrow to move gravel in smaller loads.
  • Work from above and never enter a trench deeper than your knees to work alone. A helper cannot prevent a cave-in. Keep spoil and equipment back from the edge, and get professional help if the trench is unstable or you cannot work from above.

Estimates only. Check quantities with your supplier before you buy. © 2026 HouseCalcs