How to build a block retaining wall
Build a short segmental block garden wall up to about 3 feet high. Taller walls, walls holding back a slope near a building, driveway, or property line, and walls with a load above them need an engineer and often a permit.
This guide covers a low garden wall made with interlocking blocks. Follow the block maker's limits for your site, even if they are lower than 3 feet. If the site does not meet those limits, get an engineered design before digging.
Calculators for this job
Tools
- Tape measure, stakes, and string line
- Shovel and rake
- Plate compactor and hand tamper
- Level and rubber mallet
- Caulk gun and block saw if needed
Materials
- Segmental retaining wall blocks and caps
- Crushed gravel for the leveling base
- Clean drainage gravel
- Perforated drain pipe and outlet fittings
- Water-permeable landscape fabric and landscape block adhesive
- Topsoil
Steps
Check the rules and mark utilities
Ask your local building department about height limits, permits, setbacks, and how wall height is measured. Check the block maker's limits for the wall and soil conditions. Call 811 and wait for utility markings before digging.
Mark the wall line
Set stakes and a string line along the front of the wall. Check where the drain can exit downhill at one end without sending water toward a building or onto a neighbor's property.
Dig and compact the trench
Dig wide enough for the blocks, the gravel base, and the drainage backfill behind the wall. Follow the block maker's dimensions for the base thickness and how much of the first course to bury. Remove soft spots and compact the trench bottom before adding gravel.
Build the leveling base
Place crushed base gravel in layers and compact each layer to the block maker's specifications. Check that the finished gravel base is level along the wall and from front to back.
Set the first course
Start at the lowest end. Set each block on the base and check it side to side, front to back, and against its neighbors. Adjust the gravel and tap the block into place with a rubber mallet. This course sets the level for every row above it.
Install the drain and fabric
Place water-permeable landscape fabric between the native soil and the drainage gravel. Set the perforated drain pipe behind the first course as the block maker directs, sloping it to an outlet that opens to daylight at one end. Make sure the outlet can discharge freely to a safe location.
Stack and backfill one course at a time
Brush loose gravel off the blocks before laying the next row. Stagger the joints and engage the block's built-in setback so each row steps back as designed. Add clean drainage gravel behind each course, keep the fabric between the gravel and soil, and compact the soil backfill in layers as directed.
Glue the caps
Dry-fit the caps and check their overhang. Clean the top course and glue the caps with landscape block adhesive made for outdoor use. Follow the adhesive label for surface preparation and cure time.
Grade the topsoil
Finish behind the wall with topsoil as the block maker directs. Shape the surface so runoff goes away from the wall rather than pooling behind it. Keep the drain outlet clear.
Tips
- Spend most of your setup time on the first course. Correct any uneven blocks before adding another row.
- Check level on every block, front to back and side to side.
- Rent a plate compactor for the base and follow the block maker's instructions for compacting near the wall.
Safety
- Blocks are heavy. Lift with your legs, get help with awkward pieces, and wear gloves, sturdy boots, and eye protection.
- Wet-cut blocks to control silica dust and wear a properly fitted respirator rated for silica dust. Follow the saw maker's safety instructions.
- Always call 811 before digging and follow the instructions for working near marked lines.