How to build a raised garden bed

Build a simple wood box for vegetables, level it on the ground, and fill it with the right amount of soil.

About half a day Easy

This guide covers an open-bottom raised bed that sits on the ground. Use the calculators to estimate lumber and soil before buying, then check the inside measurements of the finished box before filling it.

Start this project

Calculators for this job

Tools

  • Tape measure, pencil, and square
  • Hand saw or circular saw
  • Drill and driver bits
  • Level, shovel, and rake
  • Wheelbarrow and garden hose

Materials

  • Cedar, untreated lumber, or lumber rated for garden use
  • Corner posts and a center brace for beds 8 feet or longer
  • Exterior screws
  • Plain cardboard or galvanized hardware cloth if needed
  • Topsoil and soil amendments from the calculator

Steps

  1. Pick a spot

    Choose a level spot with a hose or other water source nearby. Most vegetables need 6 to 8 hours of direct sun a day. Check for shade from trees and buildings before picking the spot.

  2. Choose a size you can reach across

    Make the bed no more than 4 feet wide if you can reach it from both long sides. Go narrower if you can only work from one side. Mark the footprint and check that you can reach the middle without stepping in the bed.

  3. Choose the lumber

    Use cedar, other untreated wood, or lumber rated for garden use. Make a cut list for the sides, ends, posts, and any brace. Use the board-foot calculator to estimate the lumber volume, then use your cut list to choose boards at the store.

  4. Cut the boards to length

    Measure the actual thickness of the lumber and allow for it where boards overlap at the corners. Mark square cuts, support the boards, and cut matching pairs for the long sides and ends.

  5. Build the box

    Fasten the boards to the corner posts with exterior screws. Measure across both diagonals and adjust the box until the measurements match. On beds 8 feet or longer, fasten a center brace across the two long sides to keep them from bowing outward.

  6. Level the box on site

    Set the empty box in place and check it with a level from side to side and end to end. Shave down high spots with a shovel so the boards rest evenly on the ground.

  7. Cover the bottom if needed

    Lay overlapping pieces of plain cardboard with the tape removed to smother grass and weeds. If burrowing pests are the problem, use galvanized hardware cloth instead and fasten its edges to the box so there are no gaps.

  8. Fill with the soil mix

    Measure the inside length and width in feet and enter the soil depth in inches in the raised bed soil calculator. Use its mix amounts to measure out the soil and amendments. Blend them as you fill the box and rake the surface level.

  9. Water it in before planting

    Water the bed gently to settle the mix. Let it drain and settle, then top up any low spots before planting.

Tips

  • About 10 to 12 inches of soil is enough for most vegetables. Give deep-rooted crops more room if roots cannot grow into the ground below.
  • Leave 2 to 3 feet between beds for a wheelbarrow. Check the width of your wheelbarrow before placing the boxes.
  • Top up the bed with compost each season as the soil settles.

Safety

  • Wear gloves when handling rough boards and hardware cloth, and wear eye protection when cutting. Follow the saw maker's instructions on glove use near moving blades.
  • Bend your knees and lift soil bags with your legs. Keep bags close to your body and use a wheelbarrow for heavy loads.
  • Call 811 before driving stakes or posts deep into the ground. Wait for utilities to be marked before disturbing the ground.

Estimates only. Check quantities with your supplier before you buy. © 2026 HouseCalcs